The Fleck 5600 Cycle Actuator Gear (model 13802) is the precision-molded drive component that advances your control valve through regeneration cycles. When your softener skips cycles or fails to advance properly, this gear assembly is typically the culprit.
SPECIFICATIONS
Technical Details
| Part Number | 13802 |
| Manufacturer | Fleck |
| Compatible Valve | Fleck 5600 Series |
| Component Type | Cycle Actuator Gear |
| Material | Engineered Polymer |
| Function | Timer/Cycle Advancement |
| Category | Control Valve Parts |
| Service Life | Variable (depends on usage) |
INSTALLATION & USE
Replacement Procedure
- Disconnect power to the Fleck 5600 control head and relieve system pressure
- Remove the control head cover and locate the timer motor assembly on the right side of the valve
- Carefully extract the old cycle actuator gear from the drive shaft, noting its orientation and position
- Install the new 13802 gear onto the drive shaft, ensuring proper engagement with the cam assembly
- Reassemble the control head, restore power, and manually advance through one regeneration cycle to verify operation
COMPATIBILITY
System Requirements
This cycle actuator gear is engineered specifically for Fleck 5600 series control valves, including 5600SXT and 5600 Econominder models. It interfaces with the timer motor assembly to advance the valve through backwash, brine draw, rinse, and return-to-service positions during regeneration. Not compatible with Fleck 2510, 5800, or 7000 series valves, which use different gear configurations. Verify your control valve model number before ordering.
🔧 Pro Tip: Before replacing the gear, inspect the timer motor shaft for wear or debris buildup. A worn shaft can cause premature gear failure. Apply a small amount of silicone grease to the gear teeth during installation to reduce friction and extend service life.
