10 inch×2.5 inch 5 Micron Grooved Sediment Melt Blown Filters Cartridges (Compatible Replace Aqua-Pure AP110 Whole House) by IPW Industries Inc.
10×2.5 Inch Grooved Sediment Filter Cartridge
This 10×2.5 inch grooved sediment cartridge uses multi-layered melt blown polypropylene to trap larger particles in outer layers while smaller contaminants penetrate deeper into the media. The grooved surface increases filtration area by approximately 40% compared to smooth cartridges, extending service life and reducing changeout frequency in whole house applications.
Filter Construction & Performance
| Dimensions | 10 inch length × 2.5 inch diameter |
| Micron Rating | 5 micron nominal |
| Media Type | Thermally bonded polypropylene microfibers |
| Construction | Gradient density, multi-layered melt blown |
| Surface Design | Grooved exterior for increased surface area |
| Bonding | No chemical binders or adhesives |
| Service Life | 3 to 6 months depending on water quality |
Direct Replacement For Multiple Brands
This cartridge fits standard 10×2.5 inch whole house filter housings and directly replaces Aqua-Pure AP110, Whirlpool WHCF-GD05, and Watts FPMBG-5-975 sediment filters. The gradient density construction means larger sediment like sand and silt gets trapped in outer layers while smaller particles down to 5 microns are captured deeper in the media, giving you better dirt-holding capacity than single-layer cartridges. Each filter is individually shrink wrapped to maintain purity until installation.
