ADDRESS: 515 N. Fairview St, Santa Ana, CA 92703 | PHONE: (714) 541-6600 | SHOP NOW

Isopure Water

Pentek 3G Residential Point of Use Drinking Water System Kit with Integrated Bracket 3/8" SlimLine Clear Filter Housing; CBC-10 Filter; Wrench

Product Code 158643/155162-43/150539

$50.00

Pentek System Kit includes:

  • Pentek 158643 - 3/8" #10 3G IB Slim Line clear filter housing w/PR
  • Pentek 155162-43 - CBC-10 Carbon Block Filter Cartridge, Residential under-sink drinking water cartridge filter, chlorine, sediment, taste & odor
  • Pentek 150539 - SW-1 wrench for Slim Line housings

The Pentek 158643 3/8" #10 3G Slim Line clear filter housing is designed for residential Point of Use drinking water applications. The compact design with integrated bracket allows installation into area that have space restrictions. The housing is compatible with 10 x 2-1/2 inch size cartridges. The sump is made of clear plastic that allows for on-site viewing of flow and cartridge condition, and the cap includes a pressure relief button that simplifies cartridge replacement. The cap has 3/8" female NPT threaded inlet and outlet connections. Also included is a rubber O-ring to ensure a watertight seal. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Designed for most residential drinking water applications. Pentair housings allow installation of replaceable cartridges that fit inside housings designed to perform as a filtration system. Filtration systems can consist of a single stage or multiple stages, using one, two or more types of filter cartridges to reduce multiple contaminants. 

 

This Pentek CBC-10 carbon filter cartridge reduces fine sediment, chlorine taste and odor, and protozoan cysts in residential and commercial drinking water. It has a nominal (85%) filtration rating of 0.5 micron, and 99.95% efficiency for the reduction of protozoan cysts. It will reduce free available chlorine (FAC) at 2 parts per million (ppm) by at least 90% in up to 20,000 gallons at a flow rate of 2 gallons per minute (gpm). This cartridge is made of bonded powdered activated carbon (PAC) filter media wrapped in polyolefin with polyethylene outer netting. The nitrile butadiene rubber (Buna-N) gaskets seal the cartridge against the housing (sold separately). The cartridge has an initial pressure drop of 3.7 pounds per square inch (psi) at a flow rate of 2 gallons per minute (gpm), and operates over a temperature range of 40 to 180 degrees F (4.4 to 82.2 degrees C). This carbon block filter cartridge meets National Sanitation Foundation/American National Standards Institute (NSF/ANSI) standard 42 for quality assurance, and is for purification of residential and commercial drinking water.