The Omnipure E5605 is a 12" x 2.5" meltblown polypropylene sediment filter that captures dirt, sand, and particles down to 5 microns. Engineered with a universal cap design, this E-Series filter works with Everpure, Omnipure, and other standard permanent heads for straightforward replacement.
SPECIFICATIONS
Omnipure E5605 Technical Details
| Dimensions | 12" L x 2.5" W |
| Micron Rating | 5 Micron |
| Flow Rate | 0.5 GPM |
| Max Pressure | 125 PSI |
| Max Temperature | 100°F |
| Media Type | Meltblown Polypropylene |
| Service Life | 6 Months (typical) |
| Certification | NSF Standard 42 Tested |
INSTALLATION & USE
Replacing Your E-Series Filter
- Shut off water supply and relieve pressure by opening the filter housing or downstream faucet.
- Remove the old filter cartridge from the permanent head or housing, noting the orientation of the universal cap.
- Insert the Omnipure E5605 into the housing, ensuring the universal cap seats properly with the head.
- Close the housing, turn water supply back on, and check for leaks before returning system to full service.
- Mark your calendar to replace the filter in 6 months or when pressure drop indicates reduced flow.
COMPATIBILITY
Universal Cap Design
The E5605 features a universal cap compatible with Everpure, Omnipure ELF Series, and other standard permanent filter heads using 12" x 2.5" cartridges. This filter is suitable for both whole-house sediment pre-filtration and reverse osmosis system applications where 5 micron particulate removal is required. Verify your existing head accepts standard 2.5" diameter cartridges before ordering.
🔧 Pro Tip: Always flush the new filter for 3-5 minutes after installation to clear any loose carbon fines or manufacturing residue before connecting to drinking water lines or RO systems.
